Designing a Shorter Vertical Leg for Sanitary Steam Traps - - BioPharm International


Designing a Shorter Vertical Leg for Sanitary Steam Traps

BioPharm International
Volume 19, Issue 9


A thermostatic steam trap can be likened to a control valve with a condensate capacity (Cv) that varies from full-open to full-closed as the stem travels up and down. Manufacturers publish capacity data based on a 10 F sub-cool, which is a generally accepted benchmark for comparing traps' maximum capacity. Liquid condensate capacity is defined as in equation [1]:

where q is the flow in gal/min, P1 is the upstream condensate pressure in psia, P2 is the downstream pressure in psia, and G is the specific gravity. Therefore we solve for equation [2].

where W is the flow rate measured in lb/h, 60 is min/h and 8.337 is cold-water (25 C) density in lb/gal.

There is a limit to P2. As the condensate moves through the trap, its pressure is reduced and the hot condensate flashes. When the downstream pressure is approximately 50% of the upstream pressure, the pressure drop becomes critical. At this point the flashing steam reaches sonic velocity, which chokes off any additional flow through the steam trap. In this case the downstream pressure P2 is the vapor pressure of the flashed condensate.

Table 1. Theoretical CDS steam trap capacity (wide open Cv = 1.59; steam temperature = 20 psig).
The test trap discussed in this article is the Nicholson CDS 204 with –B bellows. It has a 5/16 in. orifice (3/4-in. inlet) with a cold water Cv of 1.59. Table 1 indicates the theoretical capacity when passing 80 C water and the published 10 F sub-cooled condensate for 20-psig steam. A theoretical capacity at a 2 F sub-cool is also shown. This calculated capacity is actually larger than the actual capacity because it assumes that the trap is fully open. At a 2 F sub-cool there is not enough temperature difference to open the trap fully, leaving the trap partially open.


Figure 2. Steam trap piping. Arrangement #1 has a three-way valve. Arrangement #2 for smaller systems has no valve.
SIP systems for vessels and associated piping are highly engineered systems. There are several different arrangements used by the biotech industry to purge air, heat up the vessel, and maintain a steam temperature of 121 C for a minimum of 15 min.

blog comments powered by Disqus



First Biosimilar Application Kicks Off Legal Battle
October 31, 2014
FDA Approves Pfizer's Trumenba for the Prevention of Meningitis B
October 30, 2014
EMA: Extrapolation Across Indications for Biosimilars a Possibility
October 30, 2014
Bristol-Myers Squibb Announces Agreement to Acquire HER2-Targeted Cancer Treatment
October 29, 2014
Amgen, Sanofi, and Ono Pharmaceuticals Partner with Universities on Transmembrane Protein Research
October 28, 2014
Author Guidelines
Source: BioPharm International,
Click here